Front seats for XT Oka

Just thought I'd put up a picture of Paul Notts' heavy duty knuckles that I picked up yesterday. Paul confirmed that they are 'solid axle' ones.

I think these are probably bullet-proof, note the six bolts and keyed steering arm compared to the 4 studs on the original ones. Also the attachment points of the tie rods are lower than standard which in my view is not an improvement but overall i'm impressed.
I'll put up a comparison shot when i get it pulled down.

Good bit of gear,when I was in Melbourne Paul showed me a lot of DANA 80 for Coaster conversion with the same knuckles and coil springs,very impressive workmanship!!
Cheers,Joe

Peter can you take a photo of both the knuckles new one /old one cheers peter

Peter
I'll do it when i get home and get it pulled to bits

Do they still have a grease nipple on top of the arms?

Outback Jack wrote: Do they still have a grease nipple on top of the arms?

No, I'll have to do that myself.

Hi

Our seats have had it and we are looking for two front Oka seats for our XT. Does anyone know of where one can source them?

Min
Oka 74

Min,
I have a couple of LT seats for sale,just need to check what the difference is between XT and LT,Which state are you from?
Cheers,Joe

Both XT/LT cab seate are the same, colours will vary

Hi Joe
I'm in NSW.However I might be able to get them across. Could you tell me what state they are in and how much you want for them.
Thanks
Min